Open CASCADE, the 3D modelling kernel
3D modeling & numerical simulation

Search the Forums
See All Topics
 

TopOpeBRep_FaceIntersector

TopOpeBRep_FaceIntersector
Yogesh Sajanikar 2013/04/01 16:52
I have two faces with essentially same surfaces (coincident surfaces). However, TopOpeBRep_FaceIntersector fails to identify that these surfaces are tangent. These surfaces are bspline surfaces. It finds the overlapping triangles, but classifies it as a non-tangent non-intersecting surfaces.

This is a bug.
Yogesh Sajanikar 2013/04/01 16:54
Further to my earlier issue. I found that analytical (implicit surfaces) are handled well, however the bspline surfaces are not handled correctly for there coincidence.

I am using TopOpeBRep_ShapeIntersector, which in turn calls TopOpeBRep_FaceIntersector.
Forum supervisor 2013/04/01 17:54
Dear Yogesh,
If you have confidence that it is a bug
you are welcome to register it in Mantis BugTracker
which is available via the Collaborative portal -
http://dev.opencascade.org/index.php?q=home/get_involved
Don't forget to attach the shapes allowing reproduce the case.
Regards
Yogesh Sajanikar 2013/04/02 13:11
Thanks,

Will try to create a test case.

Also looking for an alternative here.

~Yogesh
 
 
Latest news
  • OCCT Applications
  • Open CASCADE Technology 6.8.0 is available for download!
  • New features to enhance the development process

  • © OPEN CASCADE 2000 - 2014  |  Search  |  Contacts   |  Site map