The e:\ drive has 50G free space and I did the following procedures before the compilation: (1) delete all *.obj in .\Release directory (2) call nmake -f tkstep.mak clean (3) delete tkstep.opt and tkstep.ncb in \WindowsNT directory.
After finishing these three steps, I typed in nmake -f tkstep.mak
In addition, the RAM of my PC is 458 M and I set additional 3G virtual memory. Can anyone give some advices ? Thanks, Jie.
Paddy
2001/11/05 06:25
> Hi All, When I tried to used VC++ 6.0 to
> compile TKStep.dll on NT 4.0, the following
> error occurred (in both Release and Debug
> option):
> The e:\ drive has 50G free space and I did
> the following procedures before the
> compilation: (1) delete all *.obj in
> .\Release directory (2) call nmake -f
> tkstep.mak clean (3) delete tkstep.opt and
> tkstep.ncb in \WindowsNT directory.
> After finishing these three steps, I typed
> in nmake -f tkstep.mak
> In addition, the RAM of my PC is 458 M and I
> set additional 3G virtual memory. Can anyone
> give some advices ? Thanks, Jie.
Hi, I'm not sure if it really helps - but did you try to compile the libs in the IDE? I did so and no errors....
Regards, Patrik Müller
Jie
2001/11/06 16:18
> Hi, I'm not sure if it really helps - but
> did you try to compile the libs in the IDE?
> I did so and no errors....
> Regards, Patrik Müller
Hi Patrik,
Thanks for your email which encouraged me to have conducted another try and got succeeded in the compilation. The problem is that on my pc both VC++5.0 and VC++6.0 were installed. This kind of coexistence somehow made VC++6.0 not working well for a big project. After switcing to VC++5.0, everything became fine.
